About Me

My photo
From Rugby, Warwickshire; Went to Marlborough Secondary School; Studied at Rugby College of Engineering Technology; Worked at HM Forces - British Army; Studied at Royal School of Military Engineering; Former Maintenance Technician at International Computers Limited; Former IT Support at GlaxoSmithKline Pharmaceuticals Ltd; Lives in Letchworth

Pages

Tuesday, 28 January 2014

More new toy’s arrived today



My job lot of 4 Hornby freight stock arrived very little use hardly any witness marks on the plastic wheels and one coupling missing not bad for £14.62 + £3 PP



Sunday, 19 January 2014

Not much progress

Not much progress over the last week or so I have finished the light weathering of “Kelly”. I did however pick up six Hornby wagons on eBay for £16, 4 of which have been fitted with metal spoke fine flanged wheel sets, one of which is the Hornby track cleaning coach. 



Sunday, 22 December 2013

Warship transplant day two



Today I’m in the process of fabricating the motor mounts now the non powered bogie is in place. That was relatively easy to achieve a flat piece of card one hole and a 5mm bore spacer. To powered end is more challenging.


That’s the hard bit out of the way now its adding strengthening webs.



Webs done it's DCC ready! And the body fits. Tidy.




Saturday, 21 December 2013

Warship transplant



I have just made a start in modding my Mainline Warship “Kelly” basically I’m junking the mainline bogies and replacing them with Hornby items remove from the “Railroad” model I bought for £29 off eBay. I know these are not perfect but they are a marked improvement over the “mainline” offerings

Saturday, 14 December 2013

Rolling Road la deuxième partie


My metal sections arrived from Birmingham and I had them cut to size +.5mm to allow for machining. Unfortunately the weather is not warm enough for me to venture up to my workshop to machine the parts for assembly. 


Just to give you an idea of where I am going with this I enlisted the help of “double sided tape”. The square section will have a 6 mm hole bored through so the eight assemblies can be mounted on two parallel arms  four each side. Each side electrically isolated from each other. 



Saturday, 7 December 2013

Rolling Road



Yesterday I dismantled and salvaged 12 roller bearings from some defective hard disk drives just the job for my proposed rolling road, each bearing is 9.5mm in diameter and 6.5 mm wide and the centre is shoulders and threaded 2mm. a pair will be mounted on a section of aluminium angle, but more of that later.