The body is held on
by 4 clips 2 near the cylinders and 2 by the cab.
The motor is retained
by a single screw and spring clip.
Once these are undone the motor assembly can be removed the chassis
Next remove the pick
ups from the inside of the chassis this will free the motor from the chassis.
Gently separate the
motor from its mounting frame
Clip away all the old
wires keeping the left pickup for reuse later.
Next solder new wires
to the pickups black left red right and 2 new wires onto the motor grey left
orange right.
Wrap the motor can in
Kapton tape and refit the pickups and refit motor to its frame.
Replace the assembly back into the chassis
Test run the motor
with a 9 volt battery on the grey and orange wires.
No comments:
Post a Comment